Welcome to Sounds Heavenly!

Products for Bang and Olufsen Systems

Sounds Heavenly are pleased to offer you a wide range of cables and accessories to complement your Bang and Olufsen audio system. All of our products are designed and tested by the company founder, a graduate Electronics Engineer with over 20 years' experience of professional and high-end domestic audio systems. Sounds Heavenly are proud to offer FREE Worldwide shipping on all of our cables! Please feel free to email us with any enquiries!

Pre-Amp Kit for Bang & Olufsen Beogram Turntables

This product is a high quality, audiophile phono pre-amplifier with convertor cables to allow you to connect a B&O Beogram Turntable without a built-in pre-amp (or other brand of turntable with fitted DIN or RCA cable) into your Bang and Olufsen hifi system using the "Aux In" socket, where the Turntable has either the standard B&O 5pin or 7pin DIN plug or twin RCA plugs on a fitted cable. This kit uses premium quality, gold-plated RCA plugs and professional Neutrik DIN plugs with GOLD PLATED PINS and will fit almost all B&O audio systems manufactured since the 1960's, as well as all Beogram turntables and record players up to 1990. It will also fit almost all non-B&O turntables with a captive stereo RCA or DIN cable fitted. Also, if you have a BeoSound 4 or BeoCenter 2, this kit can be supplied with an RCA output cable instead of the usual DIN output cable at no extra cost (these can be changed using the menu on the left side of this page if required) - if you are in any doubt about suitability, please ask!

The kit includes a high quality RIAA pre-amplifier (manufactured by Vivanco), with UK 220-240 volt AC mains power supply and two convertor cables for DIN inputs and outputs. For sales to Europe and Australia, an appropriate mains adapter plug will also be supplied with the kit to allow you to plug it into the 220-240 volt AC electrical supply in the country of purchase. As with all B&O audio systems, this kit is designed to be left permanently connected to the electrical supply. Please note that this kit does not allow the turntable to accept remote control signals from the audio system. If you have a later Beogram turntable that can accept Datalink remote control signals, we can also offer custom wiring looms at extra cost to pass Datalink signals from the B&O system to the turntable - please ask for details if this is of interest!

As the kit is designed for use with the 220-240 volt AC UK, European and Australian electrical supplies, you should contact us for advice if you intend to purchase this kit to use outside the UK, EU or Australia. This kit is designed to work from voltages between 220 and 240 volts AC only and this is NOT suitable for 110 volt supplies or DC (direct current) supplies. PLEASE NOTE THAT THIS KIT IS NOT SUITABLE FOR USE IN USA, MEXICO OR CANADA.

High quality, gold plated plugs are used on our cables in preference to the cheaper plugs that you will see on many other companies' cables. Our high quality plugs give better protection against induced electrical noise, which can degrade the sound quality produced. They are also far more rugged, to give you years of listening pleasure.

Please note: Very few other companies' cables use high quality cable and plugs. Even fewer use Oxygen-Free Copper for optimum signal quality. If other companies' listings don't state these specifications, then their cables usually don't come anywhere near our quality! If you've invested in a good quality audio system, then you need good cables to get the best from it. All cables are specified and tested by the company founder, a Graduate Electronics Engineer with over 20 years experience of B&O equipment.